Matters needing attention when installing a bag filter

Bag filter is a common dust removal equipment. It is widely used in mines because of its high dust removal efficiency, good dust removal effect, good economic benefits, low emission concentration, long service life and small footprint. , cement, foundry, iron and steel, metallurgy, plastics, chemicals and other industries in the dust removal, much welcomed by enterprises. When using the bag filter, in order to make it have a more ideal use effect, we need to pay more attention to some matters during installation, otherwise the wrong installation will easily cause the bag filter to fail during work. . So what should be paid attention to when installing?

Check before installation.

Before the bag filter is formally installed, we need to conduct a detailed inspection of its various components, including the shell, clean air chamber, air distribution box, ash hopper, bypass valve, filter device (filter bag), injection and For parts such as the compressed air pipeline system, it is mainly to check whether the number of parts is correct, whether there is any damage, etc. If there is any, immediately contact the manufacturer for replacement, and ensure that the parts are intact before the official installation of the bag filter can begin.

Confirm the installation location.

In order to ensure that the bag filter can be in an ideal working state, the installation position should be identified during installation, and it should be as close as possible to the source of dust, generally 1.5 meters to 2.0 meters. Increase the resistance loss, and if the factory wants to install the bag filter outdoors, it is necessary to take protective measures. When installing, it is necessary to install a rain cover or a rain shed on the equipment, which can protect the filter from wind, Destruction of the sun and rain, which can prolong the service life of the dust collector.

After installation, do a good job of protection.

After the bag filter is installed, the inner and outer surfaces of the equipment should be primed again, and the outer surface should be painted again, which can prevent the equipment from rusting and prolong the service life of the equipment.